Flap Replacement; Maintenance & Storage - Kokido DELTA 100 Manuel D'utilisation

is in place before sliding the string of the new float through the top cover and tying a knot
to keep it in place, and then re-install the top cover with screws.
- Replace a damaged flap immediately with a new one before the next operation.

Flap replacement

MAINTENANCE & STORAGE
NOTE:
1. Be sure to clean and dry the areas around the charging port and water sensors after
every use to avoid the forming of stains (byproduct of a natural chemical reaction
between electric current and water). Otherwise, the stains can be removed by light
scrubbing with a cotton bud soaked with juice of lemon or vinegar.
2. Battery discharges on its own during storage. Make sure to fully charge the robot
before storage.
3. You must recharge the battery at least once every three months when it is not in use.
 Unplug the external adaptor from the socket and the charging cable from the external
adaptor and robot..
 Detach accessories from the robot. If necessary, rinse the robot and accessories with
fresh water. DO NOT use detergent.
 Be sure to drain the water from the robot before storage.
 Use a damp cloth to clean and dry the robot and its accessories.
 Store them in a well-ventilated area away from sunlight, heat, ignition sources, pool
chemicals and from children. Ambient temperature for storage should be 10˚C – 25˚C
(50˚F – 77˚F). NOTE: A higher storage temperature may reduce the battery life.
17