Set-Up Before Use; Adjustment Of Trajectory; Locking Pin - Kokido DELTA 100 Manuel D'utilisation

 Immediately disconnect the external adaptor from the power source if you
detect any of the following:
- Offensive or unusual odor
- Excessive heat
- Deformation, cracks, leaks
- Smoke
4. When charging is complete, disconnect the external adaptor from the
power source and unplug the charging cable from the unit and external
adaptor.
Normally the robot can operate up to 45 minutes on a full charge.
Note: Clean the debris compartment regularly. Excessive debris inside the debris
compartment increases the burden to the motor operation and shortens the operating
duration as a result.
NOTE: Rechargeable lithium-ion battery is classified as a consumable item. It has a
limited life and will gradually lose its capacity to hold a charge. Therefore, the running
time of the robot will gradually reduce after repeated charging and discharging
throughout its product life.
Once the lifespan of the battery reaches its end, refer to section "BATTERY
DISPOSAL" for instructions regarding battery disposal and replacement of swivel head.
NOTE: Let the robot rest for around 30 to 40 minutes before charging it again.
Set- up Before Use

Adjustment of Trajectory

Locking Pin

The trajectory of the robot is dependent on the position of the pin that fixes the axle to
a certain angle. Alter only the position of the pin on left.
Recommended settings:
RED light - Charging
GREEN light - Charged
12