Set-Up Before Use; Adjustment Of Trajectory; Locking Pin - Kokido Delta 200 Manuel D'utilisation

4. When charging is complete, disconnect the external adaptor from the power source
and unplug the charging cable from the unit and external adaptor.
Normally the robot can operate up to 90 minutes on a full charge.
Note: Clean the debris compartment regularly. Excessive debris inside the debris
compartment increases the burden to the motor operation and shortens the operating
duration as a result.
NOTE: Rechargeable lithium-ion battery is classified as a consumable item. It has a
limited life and will gradually lose its capacity to hold a charge. Therefore, the running time
of the robot will gradually reduce after repeated charging and discharging throughout its
product life.
Once the lifespan of the battery reaches its end, refer to section "BATTERY
DISPOSAL" for instructions regarding battery disposal and replacement of swivel head.
NOTE: Let the robot rest for around 30 to 40 minutes before charging it again.

Set-Up Before Use

Adjustment of Trajectory

Locking Pin

The trajectory of the robot is dependent on the position of the pin that fixes the axle to
a certain angle. There are two pins: the one on the right is fixed and should remain
untouched. Alter only the position of the pin on left.
Recommended settings:
NOTE: Wheel axle should be positioned above the locking pin
12