Operation - Kokido Delta 200 Manuel D'utilisation

OPERATION

WARNING!
1. Bring your robot to the side of your pool. NOTE: Do not place the robot in the pool
corner and against the pool wall as starting location.
2. Slide the power switch to the ON position and the power indicator light will turn on.
ATTENTION: Motor activates only when the robot is submerged in water completely
Power indicator
3. Immerse the robot into the water and operation will automatically begin as water level
covers the sensors at the top of the swivel head. Let the robot sink to the pool floor and
observe the cleaner's first forward and reversed movements across the pool bottom. If the
robot runs along the pool wall instead of perpendicular to it, reposition it to make sure that
its front/back faces the pool wall.
IMPORTANT NOTE:
The swivel head may rotate repeatedly for a few minutes once the robot sinks to the pool
bottom. This phenomenon will stop once the air trapped inside the robot is gradually
discharged and the robot will begin to move regularly.
Power indicator light starts to blink when 10 minutes of usage remains.
Power indicator light :
No light - Power off / no power
Light - Power on
Blinking light - Battery power will be exhausted within 10 minutes.
NOTE:
- Refrain from making any physical contact with both water sensors.
-
 To retrieve the robot from the pool, attach the hook to a telescopic pole (not provided)
and use it to retrieve the float, if you are unable to retrieve with your hands.
Once the robot reaches the water surface, grasp onto the grip underneath the wider end
of the robot base to lift the cleaner to drain the water out of the robot.
Make sure the robot is off.
light
(Green)
14