Float Replacement; Flap Replacement; Maintenance & Storage - Kokido Delta 200 Manuel D'utilisation

CAUTION!
- Replace a damaged filter cover immediately with a new one before the next operation.
- Replace a damaged float immediately with a new one before the next operation.

Float Replacement

Use a screwdriver (not provided) to unscrew the 4 screws at on the top cover of the swivel
head. Untie the knot on the string to remove the damaged float. Ensure the round switch
is in place before sliding the string of the new float through the top cover and tying a knot
to keep it in place, and then re-install the top cover with screws.
- Replace a damaged flap immediately with a new one before the next operation.

Flap replacement

MAINTENANCE & STORAGE
NOTE:
1. Battery discharges on its own during storage. Make sure to fully charge the robot
before storage.
2. You must recharge the battery at least once every three months when it is not in use.
 Unplug the external adaptor from the socket and the charging cable from the external
adaptor and robot..
 Detach accessories from the robot. If necessary, rinse the robot and accessories with
fresh water. DO NOT use detergent.
 Be sure to drain the water from the robot before storage.
 Use a damp cloth to clean and dry the robot and its accessories.
 Store them in a well-ventilated area away from sunlight, heat, ignition sources, pool
chemicals and from children. Ambient temperature for storage should be 10˚C – 25˚C
(50˚F – 77˚F). NOTE: A higher storage temperature may reduce the battery life.
16