Troubleshooting - Kokido Mangar RC32 Manuel D'utilisation

TROUBLESHOOTING

Problem
Robot does not capture the debris
Robot stopped moving in the middle of
pool but swivel head is still turning
Robot does not cover the entire poo
Robot moves along the pool wall
Robot trapped in the narrow ledge of
an in-ground pool
Robot moves slowly or does not move
at all.
Swivel head does not turn or turn
noticeably slowly
Possible Cause
Battery is running out
Impeller is jammed
Suction mouth is clogged
Impeller is broken
Debris compartment is full
Robot stopped by obstacle or
large creases in the pool liner.
Robot is stopped by suction
from the main drain of pool
floor
Debris compartment is full
Operation time is shorter as
expected
Moving direction is interrupted
by water circulation generated
by filtration system
Wheel is jammed
Position of wheel axle is not set
properly. Bumper is required
Robot moves along the pool
wall of round pool
Position of wheel axle is not set
properly / bumper is required
Not enough space for robot
turning in other direction
Debris compartment is full
Suction mouth is clogged
Filter cover screen is clogged
Impeller is jammed
Swivel head bottom is jammed
Side flap does not come up.
Swivel smoothing- ring is
broken
Swivel head bottom plate fitting
on the head is stripping
threaded
Solution
Charge the robot again.
Power off the robot and inspect the hole under the swivel
head to see if the impeller is jammed by large debris. If
necessary, contact your dealer for further instructions.
WARNING!
Make sure the robot is off before
the unit is serviced.
Remove clogged objects from the suction mouth.
Contact your dealer for replacement.
Clean both debris compartment and filter cover.
Check to see that if there is anything obstructing the
cleaner. Remove the obstacle.
Turn off the filtration system as instructed in manual.
Clean the debris compartment
Clean the filter compartment and recharge the robot for
4.5- 5 hrs
Turn off the filtration system as instructed in manual.
Check and remove debris from the wheel.
Follow instruction to adjust wheel axle setting and apply
bumper.
Make sure the bumpers have been installed as instructed
in manual.
Follow instruction to adjust wheel axle setting and apply
bumper.
Follow instruction to put bumper on both end of robot.
Clean both debris compartment and filter cover.
Remove clogged objects from the suction mouth
Flush the screen with water to remove small particles. If
brush is deem necessary, use a soft brush to clean the
screen gently.
Power off the robot and inspect the hole under the swivel
head to see if the impeller is jammed by large debris. If
necessary, contact your dealer for further instructions.
WARNING!
Make sure the robot is off before
the unit is serviced.
Check and remove any debris that may be trapped under
the swivel head.
Check and remove any debris that hinders the
movement of the flap.
Check that the two floats are on the flap.
Replace with a new swivel smoothing-ring. Contact your
dealer for replacement parts.
Unfasten the plate completely and fasten again. (Avoid
stripping threaded fitting.)
19