Troubleshooting - Kokido Telsa 80 Manuel D'emploi

TROUBLESHOOTING

Problem
Pool vacuum does not
capture the debris
Debris escapes from
the filter base
Handle / pole
connector cannot be
secured in assembly
Pool vacuum cannot
be charged / recharged
Cleaner does not move
smoothly
Environmental Programmes, WEEE European Directive
Please respect the European Union regulations and help to protect the environment.
Return non-working electrical equipment to a facility appointed by your municipality that properly recycles electrical
and electronic equipm ent. Do not dispose them in unsorted waste bins. For items containing removable batteries,
remove batteries before disposing of the product..
© 2016 Kokido Development Ltd.
All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording, or otherwise, without prior written permission of Kokido
Development Ltd.
If soft copy of this instruction manual is required, please contact our customer service by email:
customerservice@kokido.com
Possible Cause
Battery is running out
Impeller is jammed
Impeller is broken
Filter base is full
Larger debris / large
volume of debris
Suction nozzle flap is
broken
Draining filter plate is
damaged
Side pin is broken
Battery is damaged
Contact plates of the
charger base and unit
are not connected.
External adaptor is out
of order
Wheel is jammed/
damages
Brushes underneath is
damaged
(v1)
Solution
Charge the battery again.
Power off the pool vacuum and visually check the gap
in middle of the pool vacuum to see if the impeller is
jammed by larger debris. If possible, use a small tool
to remove it with intensive care & caution. If
necessary, contact your dealer for further instructions.
WARNING
! Make sure the pool vacuum is
powered off when the unit is being serviced.
Contact your dealer for impeller replacement.
Clean the filter base .
Remove the brushes from the filter base bottom
Suction nozzle flap works like a door to prevent the
debris from escaping from the filter. Contact dealer for
replacement parts and instruction.
Replace with a new draining filter plate.
Replace with a new handle / pole connector.
Contact dealer for battery replacement.
WARNING!
DO NOT open the pool vacuum and
replace the battery by yourself. This could result in
severe or fatal injuries and the warranty will be voided
as a result.
Make sure that the charger base is assembled on the
unit properly so that their contact plates are touching.
Contact dealer for replacement.
WARNING!
Using the wrong external adaptor
will result in damaging the pool vacuum / battery and
voiding the warranty as a result.
Clean the wheels. Replace damage wheels.
Replace damaged brushes
16