Emptying The Filter Base - Kokido Telsa 80 Manuel D'emploi

CAUTION! Make sure the pool vacuum is always facing downwards when it is
removed from the pool. Otherwise, the pole connector may be bent and damage the
pool vacuum in the process. Make sure to hold the handle as well when lifting the pool
vacuum out of the water.
3) Rinse the pool vacuum with fresh water after every use. DO NOT use any
detergent.

EMPTYING THE FILTER BASE

WARNING!
Using the pool vacuum without a filter screen in place will VOID
your warranty.
In order to maximize the cleaning efficiency, be sure to clean the filter cone before
and after each use.
CAUTION! If the pool vacuum is charging, disconnect the external adaptor from the
power source and detach the pool vacuum from the charging base.
Emptying filter base
1. Place the pool vacuum on a stable surface.
2. Release the rear body from the transparent lid.
3. Push on and rotate the tabs on the transparent round cover clockwise until the
orange bar on the transparent cover and the base are aligned. Lift the transparent
cover off the base. Hold the small grips on the top of the filter cover to lift it off the
base and gain access to the debris.
4. Clean out all debris from the base, suction nozzle flap, and draining filter plate.
Use clean water to rinse the entire base. To detach the filter plate, pry the rib of the
plate. If the draining filter plate is damaged, replace it with a new one before the
next operation.
Note: Do not remove the draining filter plate. Without it, debris will escape from the
base's debris compartment during operation.
5. Reverse the steps to install the filter and cover onto the base. Make sure the flange
of the transparent cover is under the arch.
12