Maintenance & Storage - Kokido Telsa 80 Manuel D'emploi

MAINTENANCE & STORAGE
NOTE:
1. Battery discharges on its own during storage. Make sure to fully-charge the pool
vacuum before storage.
2. You must re-charge the battery at least once every three months when it is not in
use.
Unplug the external adaptor from the socket and then unplug the adapter jack from
the charging base.
Detach accessories from the pool vacuum. If necessary, rinse the pool vacuum and
accessories with fresh water. DO NOT use detergent.
Make sure to drain the water from the rear body through the holes located inside
the chamber that connects to the handle/ pole connector, and the hole on the rear
of the body.
Make sure to drain the water from the handle through its hole on the bottom end.
Use a damp cloth to clean and dry the pool vacuum and its accessories.
Store them in a well-ventilated area away from sunlight, heat, ignition sources, pool
chemicals and from children. Ambient temperature for storage should be 10˚C –
25˚C (50˚F – 77˚F). NOTE: A higher storage temperature may reduce the battery
life.
WARNING!
Never attempt in any way to disassemble the pool vacuum.
-
Under no circumstances should you attempt to disassemble the pool vacuum and
-
replace the impeller, motor and battery by yourself.
13