Assembling The Machine; Switching The Machine On/Off - Festool SRM 45 E-LHS 225 PLANEX Notice D'utilisation D'origine/Liste De Pièces De Rechange

Save all warnings and instructions for future
reference.
- The machine should only be used by appointed
persons instructed in correct machine han-
dling.
- Use original Festool accessories only.
- Warning: the machine may contain hazardous
dust. Only authorised and qualifi ed personnel
with suitable protective equipment may perform
maintenance work, including emptying the con-
tainer and changing the fi lter. Do not operate the
machine without a fully fi tted fi lter system.
- The machine is not intended for use by persons
(including children) with limited physical, sensory
or mental ability or without suffi cient experience
and/or knowledge, unless they are supervised by
a person responsible for their safety or have been
instructed on how to use the machine. Children
should always be supervised to ensure that they
do not play with the machine.
- Observe the safety requirements that apply for
the dust you intend to extract.
- Risk of explosion and fi re hazard: do not extract
sparks or hot dust, fl ammable or explosive dust
(e.g. magnesium, aluminium), fl ammable or
explosive fl uids (e.g. petrol, thinner), aggressive
fl uids/solids (e.g. acid, leach, solvent). This mo-
bile dust extractor is suitable for extracting paint
dust. Operate the machine in a well-ventilated
room!
- Pull the plug from the socket when the machine
is not in use and prior to maintenance and clean-
ing work.
- Check the plug and the cable regularly and have
them replaced by an authorised after-sales serv-
ice workshop should either become damaged.
- Always replace the mains power cable with the
type specifi ed in the manual.
- Do not damage the mains power cable (e.g. by
driving over, dragging, etc.). Do not pull the plug
from socket by the cable.
- Always use the machine socket for the purpose
specifi ed in the manual.
- Clean the integral water level fl oat regularly and
check for damage.
- Do not expose the machine to rain.
- Do not lift or transport the machine by the handle
using a crane or lifting gear.
- For reasons of safety, never operate the machine
from an unearthed socket.
All manuals and user guides at all-guides.com
6
Risk of accident if the machine is operated using
unauthorised voltages or frequencies.
- The operating voltage specifi ed on the mobile
- Make sure that the mobile dust extractor is
6.1
The parts included in the scope of delivery are en-
closed inside the dust container [1-1] on delivery
and must be removed before initial use.
• Affi x the accompanying sticker in your national
Inserting the fi lter bag/disposal bag
• Remove the top section [Fig. 2].
• Insert the disposal bag [Fig. 3] or the fi lter bag
• Replace the top section and close the locking
Inserting the cable hook
• Slide the cable hook [1-7] for storing the mains
6.2
To use the mobile dust extractor in combination
with the PLANEX:
• Fit the tool holder as described in the there en-
• You can store sandpaper, the brush segment and
• Only use disposal bags when performing extrac-
6.3
"0" switch position
Appliance socket [1-5] is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket is connected to the power, extrac-
tion motor starts.
"Auto" switch position
Appliance socket is connected to the power, extrac-
tion motor starts when the connected machine is
switched on.
14
Commissioning
WARNING
dust extractor name plate must match the
voltage of the mains power!
switched off when plugging in the mains ca-
ble.

Assembling the machine

language over the text fi eld on the warning sign
[1-3].
[Fig. 4].
clips.
power cable into the holder [1-8] from above.
Preparing for use with the PLANEX
closed installation instructions.
the PLANEX on the tool holder storage area.
tion work with the PLANEX.

Switching the machine on/off

Make sure that the connected machine is
switched off before actuating the switch [1-4].