STERWINS 1200 BC-2 Mode D'emploi page 272

Suspected malfunctions are often due to causes that the users can fix
themselves. Therefore check the product using this section. In most
cases the problem can be solved quickly.
Problems
Not connected to power supply
Product does not
Power cord or plug is defective
start
Other electrical defect to the
product
Extension cord not suitable for
operation with this product
Product does not
Power source (e.g. generator)
reach full power
has too low voltage
Air vents are blocked
Unsatisfactory
cutting
Cutting attachment is worn
performance
Cutting attachment is dull/
Excessive
damaged
vibration or noise
Bolts/nuts are loose
Possible cause
271
5.TROUBLESHOOTING
Solution
Connect to power supply
Check by a specialist electrician
Check by a specialist electrician
Use a proper extension cord
Connect to another power source
Clean the air vents
Replace with a new one
Replace with a new one
Tighten bolts/nuts
EN