Graco SnugGlider 1F01GSV Manuel D'utilisateur page 13

Table des Matières

Publicité

• Démarrer la balançoire
• Activación del columpio
12
WARNING
Always use infant car seat harness.
TO TURN SWING ON:
Rotate the speed dial up, and lightly push the swing to get it started.
Observe the swinging motion for a minute. It takes time for the swing
to adjust to a setting. Change setting if needed by moving the dial up
for faster speeds or down for slower.
TO TURN SWING OFF: Turn dial down until it "CLICKS" into the
"OFF" position.
A small, quiet baby will swing higher on each setting than a larger,
more active baby.
Your seat may be stopped at any time the motor is running without
damaging the motor. Push swing to restart.
If your swing motor stops operating by itself, a protective device may
have been activated. Turn off motor, wait three minutes, then restart
swing.
Starting Swing
avoid serious injury from falling or sliding out.
ON
Allumé
Encender
Speed Dial
Cadran de vitesse
Dial de la velocidad
OFF
Fermé
Apagar
13

Publicité

Table des Matières
loading

Table des Matières