Electrical Connections; Ordering Accessories - Federal Signal Vibratone 350 Instructions D'installation Et D'entretien

Electrical Connections

The Model 350 is provided with two leads for
electrical connections.
1. Connect the line (L or L1) power source lead
to the black wire and connect the neutral (N
or L2) power source lead to the white wire
with user-supplied connectors.
2. Connect the ground to the green ground
screw if required.
Optional Volume Control
The 350 horn is shipped with the volume set for
maximum sound output. However, you can reduce
the sound level with the provided 10-32 hex socket
head set screw. To adjust the volume:
1. Before installing the set screw, thread the
provided 10-32 hex head tapping screw into
the hole on the front of the horn shown in
Figure 8.
Figure 8
2. Remove the tapping screw, and then thread
the set screw into the threaded hole.
3. Use a 3/32-inch hex key wrench to rotate the
set screw clockwise until the desired sound
level is reached.
2645 Federal Signal Drive, University Park, Illinois 60484
Additional translations available at signaling.fedsig.com
Traducciones adicionales disponibles en signaling.fedsig.com
Customer Support 1-800-344-4634+1-708-534-4756, iordersup@fedsig.com
Technical Support 1-800-755-7621+1-708-587-3587, signalsupport@fedsig.com
signaling.fedsig.com
To make the connections:
SOUND HAZARD: Wear hearing protection when
working with this horn.
PELIGRO DE SONIDO: Lleve protección auditiva
cuando trabaje con la bocina.
DANGER DU SON : Porter une protection auditive
lors de l'utilisation le klaxon.
ALLEN-HEAD ADJUSTMENT SCREW:
For softer sound, turn clockwise
Tornillo de ajuste con cabeza allen
(para un nivel de sonido más suave, gire
en sentido horario)
Vis de réglage à tête allen (pour un niveau
sonore plus faible, tournez dans le sens des
aiguilles d'une montre)
Testing/Operating
After installation, test the system to verify that
each signal operates. Establish a program for
periodic testing of the device. Provide a copy of
these instructions to all operating personnel.

Ordering Accessories

See Table 2 for available accessories.
Description
Semi-Flush Mounting Plate
Flush Wall Mount Box
Flush Mount Grille
Weatherproof Back Box
Panel Mount Trim Ring
Panel Mount Gasket Kit
Double Projector
Maintenance and Service
Technical Assistance: Contact our Technical
Support Team at +1 708-587-3587 or
signalsupport@fedsig.com.
Repair Service: A return authorization is required.
Contact your Authorized Distributor or Federal
Signal Customer Support. Defective products under
warranty will be repaired or replaced at Federal
Signal's discretion.
Product Returns: Returns require authorization
290A7445
from Federal Signal. Contact your Authorized
Distributor for more information on our return
policy or to request a return.
Table 2 Accessories
Model/Part Number
SF
FB
FG
WB
TR
K835666A
PR2-NM
256918 Rev. K2 0921