Mounting The Wall Bracket; Use - DS Produkte PC-P002 Mode D'emploi

Mounting the wall bracket

ATTENTION!
❐ Select a suitable place for the wall bracket, which should be as dry as possible and
close to a socket.
❐ Make sure that you do not drill into and/or destroy any lines. Make sure you
know where any lines are located and bypass them.
1. Now hold the wall bracket on the selected area and mark the drill holes with a pencil.
2. Then mount the wall bracket on the wall with the corresponding screws and dowels.
3. If the jack plug is not already mounted in the wall bracket, insert it in the designated
bracket.

Use

ATTENTION!
❐ Make sure that there are no large, pointy objects on the area to be cleaned.
❐ Empty and clean the dust bin after every use (see chapter "Cleaning and storage").
❐ Do not use the device if it is connected to the charger.
1. Insert one of the adapters in the suction opening on the front of the dust bin.
2. Use the short nozzle to remove dirt on smooth surfaces.
3. Use the tile nozzle to vacuum clean fabric folds, tiles, corners, nooks and crannies or
other hard-to-reach areas.
4. Use the brush adapter to dust delicate objects such as picture frames, lamp shades,
keyboards, books etc.
5. Push the On/Off button to turn on the device. The device starts to vacuum clean.
6. Run the device over the area to be cleaned. The device is also suitable for vacuuming
up small amounts of liquids (approximately 250 ml).
7. Push the On/Off button to turn on the device.
01087_DE-GB-FR-NL_V3.indb 18 01087_DE-GB-FR-NL_V3.indb 18
All manuals and user guides at all-guides.com
18
28.01.2014 15:45:07 28.01.2014 15:45:07