Festo SFC-DC IO Serie Instructions D'utilisation page 24

5 Menu structure (control panel)
Menu
command
Diagnostic
Pos. set table
Axis param
System paramet.
SW information
1) 2)
Positioning
Homing
Move pos. set
Demo pos. table
1) 2)
Settings
Axis type yp
Axis parameter p
Homing paramet. Homing method
24
Description
Display the system data and the settings currently in effect
Display the position set table
Display axis parameters and data
Display system parameters and data
Display the operating system version (firmware)
Reference run and positioning runs for testing the position sets
Start reference run
Start positioning run Position set"
Start positioning run Position set table"
Selection of the drive, parametriz., programming the position sets
SLTE_10_50_G04
...
SLTE_16_150_G04
3)
Zero point
3)
SW limit neg
3)
SW limit pos
SAVE...
Velocity v_rp
Velocity v_zp
SAVE...
Electric mini−slide SLTE−10, travel 50
...
Electric mini−slide SLTE−16, travel 150
Offset of axis zero point
Stroke limitation: Software end position,
negative
Stroke limitation: Software end posit., positive
Save parameters in EEPROM
Selection of referencing method
(stop, reference switch)
Positioning speed for searching for the
reference point
Positioning speed for moving to the axis zero
point
Save parameters in EEPROM
Festo P.BE−K−SFC−DC−IO 0503NH English