R&G RGH0001BK Instructions De Montage

Les langues disponibles

Télécharger ce manuel

FITTING INSTRUCTIONS FOR RGH0001BK REAR WHEEL HUGGER

THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW.

DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT.

There should also be a white spacing block in the kit (not pictured)

Please note that the way the kit is packed does not necessarily represent the way of

HE PARTS SHOWN MAY BE REPRESENTATIVE ONLY

HUGGER

(HUG0001)



Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ

Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301

HONDA VFR 1200

mounting to the bike

M6 WASHER

25mm OUTSIDE

DIAMETER (x2)

TOOLS REQUIRED

SET OF METRIC ALLEN KEYS TO INCLUDE 4mm A/F.

R&G Racing

www.rg-racing.com

(

FOR CLARITY OF INSTRUCTIONS ONLY

M6x20mm LONG

BUTTON HEAD

BOLTS (SILVER x2)

Email:

info@rg-racing.com

)

M6x20mm LONG

BUTTON HEAD

BOLTS (BLACK x1)

SPACER (S0380)

(x1)

Page 1 FITTING INSTRUCTIONS FOR RGH0001BK REAR WHEEL HUGGER HONDA VFR 1200 THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW. DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT. There should also be a white spacing block in the kit (not pictured)
Page 2: Fitting Instructions
 19mm SOCKET AND WRENCH.  TORQUE WRENCH (108Nm AND 17Nm).  12mm SOCKET AND WRENCH.  12mm A/F SPANNER. FITTING INSTRUCTIONS If a centre stand is fitted, continue with wheel removal as described below. If a centre stand is not fitted, we recommend fitting by a qualified motorcycle mechanic.
Page 3  Offer the hugger into position.  Place the black button headed bolt through the hole in the side lug of hugger and through the already positioned new spacer into the swing-arm, do not tighten yet.  Fit the two silver button headed bolts with washers through the holes in the hugger and engage the threads in the swing-arm, do not tighten yet.
Page 4: Outils Necessaires
FRANCE INSTRUCTIONS DE MONTAGE DU RAS DE ROUE RGH0001BK HONDA VFR 1200 VERIFIER QUE TOUTES LES PIECES MONTREES SUR LES PHOTOS SONT BIEN PRESENTES DANS LE KIT. Le kit doit contenir également une entretoise blanche (non présentée sur les photos).
Page 5  Placer les rondelles sur les deux vis M6 (têtes arrondies).  Enlever 3-4mm du ruban adhésif présent sur le ras de roue, et laissez l'étiquette pour faciliter le déplacement de la pièce durant le montage.  Placer le ras de roue en position. ...