Beurer EM 29 Mode D'emploi page 83

Table 3
Guidance and manufacturer's declaration – electromagnetic immunity
The EM 29 is intended for use in the electromagnetic environment specified below. The customer or the user of the EM 29
should assure that it is used in such an environment.
IMMUNITY test
Electrostatic discharge (ESD)
IEC 61000-4-2
Electrical fast transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short interrup-
tions and voltage variations
on power supply input lines
IEC 61000-4-11
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
NOTE: UT is the a.c. mains voltage prior to application of the test level.
Table 4
Recommended separation distances between portable and mobile RF communications equipment and the EM 29
The EM 29 is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The cus-
tomer or the user of the EM 29 can help prevent electromagnetic interference by maintaining a minimum distance between
portable and mobile RF communications equipment (transmitters) and the EM 29 as recommended below, according to the
maximum output power of the communications equipment.
Rated maximum output
power of transmitter
(W)
0,01
0,1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters (m)
can be determined using the equation applicable to the frequency of the transmitter, where P is the maximum output power
rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflec-
tion from structures, objects and people.
All manuals and user guides at all-guides.com
IEC 60601 test level
± 6 kV contact
± 8 kV air
± 2 kV for power sup-
ply lines
± 1 kV line to line
± 2 kV line to earth
<5 % UT (>95 % dip in UT)
for 0.5 cycle
40 % UT (60 % dip in UT)
for 5 cycles
70 % UT (30 % dip in UT)
for 25 cycles
<5 % UT (>95 % dip in UT)
for 5 s
3 A/m
Separation distance according to frequency of transmitter
150 kHz to 80 MHz
d = 1.2 x P 1/2
0,12
0,38
1,2
3,8
12
Compliance level
± 6 kV contact
± 8 kV air
± 2 kV for power sup-
ply lines
± 1 kV line to line
± 2 kV line to earth
<5 % UT (>95 % dip in UT)
for 0.5 cycle
40 % UT (60 % dip in UT)
for 5 cycles
70 % UT (30 % dip in UT)
for 25 cycles
<5 % UT (>95 % dip in UT)
for 5 s
Not applicable
(m)
80 MHz to 800 MHz
d = 1.2 x P 1/2
0,12
0,38
1,2
3,8
12
83
Electromagnetic environment –
guidance
Floors should be wood, concrete
or ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30 %.
Not applicable
Not applicable
Not applicable
Not applicable
800 MHz to 2,5 GHz
d = 2.3 x P 1/2
0,23
0,73
2,3
7,3
23