Instructions For Using The Battery; Disposal Of Accumulators - IKRA HATI 18 LI Manuel D'utilisation

Masquer les pouces Voir aussi pour HATI 18 LI:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24

Instructions for using the battery

1. When the hedge shears are delivered, the replacea-
ble battery is not charge. Before starting the machine
for the first time, the battery must be charged
2. You must never open the battery.
3. Never throw the used batteries in fire - RISK OF
EXPLOSION!
4. Connect the battery charger only to mains with such
a voltage as stated on the type-bearing plate.
5. Use only the original battery.
6. Never charge the battery with a battery charger
from other producer. This can result in the battery
being damaged or it can result in an injury due to
over-heating.
7. During a long-term operation, the battery may heat
up. Let it cool down before charging it.
8. Do not store the battery charger and the batteries
within children's reach.
9. Do not use the battery charger in an environment with
vapors or inflammable fluids.
10. Charge the batteries only at a temperature within the
range of 10°C to 40°C.
11. Store the battery at temperatures up to 30°C only.
Higher storage temperatures may result in damage
to the battery. The ideal storage temperature range
is 10-15°C.
12. Protect the battery from heat, intense insolation and
fire. Explosion hazard!
13. In case of damage to the battery, hazardous vapours
or fluids may escape. In case of incidental contact
flush with water and seek medical advice immedi-
ately. The fluid may have irritating or caustic effects
on the skin.
14. Never short-circuit the contacts of the batteries and
never interconnect them with metal objects.
15. When transporting the battery, take care that the
contacts are not interconnected, do not use metal
transportation containers.
16. Short-circuit of the battery can lead to explosion. In
any case, the short-circuit connection will damage
the battery.
17. Check the cable regularly on whether it is damaged.
If the cable is damaged, have it replaced.
18. The battery is equipped with a deep-discharge pro-
tection feature: the tool is automatically switched off
if the battery is discharged. Recharge the battery
immediately if this should be the case.
19. Before storing the batteries for the wintertime, charge
them fully once more.

Disposal of accumulators

Please observe the following directions for the
disposal of your accumulator/battery. Batteries
are not to be put into the rubbish. As a consum-
er you are legally obliged to return used batter-
ies and accumulators. At the end of the duration
of your apparatus, the batteries or accumulators
have to be taken from the apparatus, disposing
of them separately. You have the possibility of
delivering your old batteries and accumulators
to the local collecting points of your municipality
or to your dealer or to the distribution centers.
All manuals and user guides at all-guides.com
GB | Operating Instructions
Charging the batteries
• In order to remove the rechargeable battery from the
• Plug the charging device (16) into the mains socket.
• Slide the rechargeable battery (14) into the charging
• The battery charging process now begins and is sig-
• Once the rechargeable battery has been fully charged,
• Charging takes approx. 3-5 hours. The battery heats
Note: Occasionally, the permissible temperature range
may be exceeded during the charging cycle. In this case,
the electronic charging control interrupts the charging
cycle to avoid any damage to the battery. The read
control light will then glow continuously. If you should
witness this, pull the battery from the charging station
and let it cool down for about 30 minutes. Then, restart
the charging cycle by sliding the battery back onto the
charging station.
• It is not required to monitor the charging time.
• Pull the plug of the charging unit if it is not in use.
• If the battery is not lit up, check if there is electric cur-
Push the button X to check the charging level (fig. 2).
The following indications may occur:
Note! The battery (14) will not reach its full capacity
when charged for the first time. The red light illuminates
until the charging device (16) is disconnected from the
mains. Multiple charging cycles may be required in order
to reach the maximum charge.
Note: The battery is equipped with a deep-discharge pro-
tection feature: the tool is automatically switched off if the
battery is discharged. Recharge the battery immediately
if this should be the case.
Thermal and voltage protection
If the tool is subject to excessively high loads for an ex-
tended period, the rechargeable battery may switch off.
If this occurs leave the battery to cool down for approx.
30 minutes.
GB-5
(fig. 1 and 2)
device, press the interlock button (15) and slide the
battery out (Fig. 1).
Make sure that the mains voltage cited on the charg-
ing station complies with the voltage supplied by your
socket. The green light on the plug-in charging device
illuminates.
station. It can only be inserted in one position (Fig. 2).
nalled by the red indicator light on the charging device
(16). The 3 green LEDs on battery (14) light up in turn.
the indicator light on charging device (16) changes
from red to green. The charging process ends auto-
matically. The 3 green LEDs on battery (14) go out.
up during the charging process. This is normal and
does not signal a fault. Remove the rechargeable bat-
tery after no more than 5 hours.
rent in the socket. If the charging of the batteries is not
possible, give the battery charger and the batteries to
a service shop.
All 3 control lights are glowing: the battery is fully
charged.
2 control lights are glowing: the charging level is still
acceptable.
1 control light is glowing: the battery is discharged.
Recharge the battery immediately!

Publicité

Table des Matières
loading

Table des Matières