Installing Stainless Steel Handle - Cavavin URBANIA CAVA46-1NDZ Mode D'emploi

INSTALLING THE STAINLESS STEEL HANDLE
This wine cellar includes a stainless steel handle that is not required to operate this unit. To install the
handle please follow the below instructions:
6. Pull away the door gasket in the area where the handle is to be installed on the left side as shown
below in Illustration # 1. The gasket is easily displaced by hand, no tools are necessary.
7. Using a Flat head screwdriver remove the two (2) pre-installed decorative plugs from the backside
of the door as shown below in Illustration #1. Save the decorative plugs for future use.
8. Insert the two (2) Phillips head handle screws with the lock washers and flat washers attached
through the gasket side of the door frame until the screws pass through the door frame. Follow the
sequence shown below in Illustration # 2.
9. Align the handle with the screws installed in the above step # 3. Tighten the screws using a
Phillips head screwdriver until the handle sets both flush and secured tightly against the door
frame. (DO NOT overtighten as this will cause damage to the handle assembly).
10. Replace the door gasket to its original position.
Illustration # 1
1 Gasket
4 Lock Washer
All manuals and user guides at all-guides.com
2 Decorative Plug
5 Flat Washer
9
Illustration # 2
3 Phillips Head Screw
6 S/S Handle