Circle Cutting - Bosch 52314 Consignes De Fonctionnement/Sécurité

BM 2610925943 6-05
the saw foot rests on the work, but with the
blade well clear of the work. Start the motor,
and then very gradually lower the blade.
When it touches, continue pressing down on
the toe of the saw foot slowly pivoting the saw
like a hinge until the blade cuts through and
the foot rests flat on the work. Then saw
ahead on the line of cut line. We do not
recommend plunge cutting with a scroll blade
(Fig. 5).
To make sharp corners, cut up to the corner,
then back up slightly before rounding the
corner. After the opening is complete, go back
to each corner and cut it from the opposite
direction to square it off. Do not try to plunge
cut into hard materials such as steel.
CIRCLE AND PARALLEL CUTTING GUIDE
This accessory is available at an extra cost. It
is used for fast and accurate straight and
circle cutting (Fig. 6).
ATTACHING GUIDE
1. Insert bar of guide through lock knob clamp,
then through the slots provided in foot, from
either side of foot with the edge guide facing
down (Fig. 6).
BAR
EDGE GUIDE DOWN
6/10/05 10:25 AM Page 10
All manuals and user guides at all-guides.com
FIG. 5
FIG. 6
LOCK
KNOB
CLAMP
GUIDE
PIN
-10-
2. Hook lock knob clamp onto edge of
footplate, adjust fence to desired width, and
securely tighten lock knob clamp.

CIRCLE CUTTING

1. Before attaching the guide, draw a circle
and predrill a 13/64" center hole in workpiece.
2. Drill or plunge cut near the circles edge,
turn saw off and move the switch lock to the
lock position.
3. Attach guide to saw with edge guide facing
UP as shown (Fig. 7).
4. Remove guide pin from end of guide, push
pin through hole provided in guide, then into
center hole of workpiece.
FIG. 7
GUIDE
PIN
HOLE
WEDGE
EDGE GUIDE UP
5. Measure the distance from the selected
hole to the blade to be equal to the circle
radius.
6. Move switch lock to the unlock position,
hold the saw firmly, squeeze trigger and
slowly push the saw forward. To make a hole,
cut from inside the circle; To make wheels or
discs, cut from the outside.
Cutting Tip: Cut slowly so the blade will stay
straight in the cut. Place small wedges in the
cut as shown in Fig. 7, to keep the inner circle
from spreading when near the end of the cut.
GUIDE
PIN
2
1