AEG FSK93800P Notice D'utilisation page 22

Masquer les pouces Voir aussi pour FSK93800P:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

22
www.aeg.com
Problem
The programme does not
start.
The appliance does not fill
with water.
The display shows the mes-
sage: Appliance is not fill-
ing water.
The appliance does not
drain the water.
The display shows the mes-
sage: Appliance is not
draining water.
The anti-flood device is on.
The display shows the mes-
sage: Appliance is flooding
or has an error in the wa-
ter inlet.
The appliance stops and
starts more times during op-
eration.
The programme lasts to
long.
The remaining time in the
display increases and skips
nearly to the end of the pro-
gramme duration.
Small leak from the appli-
ance door.
The appliance door is diffi-
cult to close.
Possible cause and solution
• Make sure that the appliance door is closed.
• Press
.
• If the delay start is set, cancel the setting or wait for the
end of the countdown.
• The appliance recharges the resin inside the water soft-
ener. The duration of the procedure is approximately 5
minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the filter in the outlet hose is not clog-
ged.
• Make sure that the interior filter system is not clogged.
• Make sure that the drain hose has no kinks or bends.
• Close the water tap and contact an Authorised Service
Centre.
• It is normal. It provides optimal cleaning results and en-
ergy savings.
• If the delay start is set, cancel the delay setting or wait
for the end of the countdown.
• Activate the TimeSaver option to reduce the pro-
gramme duration.
• Activating options can increase the programme dura-
tion.
• This is not a defect. The appliance is working correctly.
• The appliance is not levelled. Loosen or tighten the ad-
justable feet (if applicable).
• The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten the ad-
justable feet (if applicable).
• Parts of the tableware are protruding from the baskets.

Publicité

Chapitres

Table des Matières
loading

Table des Matières