Christopeit Sport AX 6000 Notice De Montage Et D'utilisation page 15

STEP 3:
Assembling of the connection cable (34) to the sensor cable (38) and
installation of support (30) at the main frame (40).
1. Place screws M8x20 (33), curved washers (31) and spring washers
(32) accessibly beside the front part of the main frame (40).
2. Place the lower end of the support (30) against the main frame
(40) and push the rubber ring (100) and support cover (101) onto the
support (30).
3. Plug the ends of the two computer cables (34-38) projecting from
(30+40) together. (Note: The connection cable (34) projecting from
the support (30) must not slide into the tube, as it is required for later
steps of installation.) When joining the tubes, ensure that the cable
connection will not trapped.
4. Connect the middle section tension cable (39) to the bracket of
lower section cable tension (35) (See figure A1-A3). Before this step
of the installation, it is advisable to adjust the resistance setting to the
lowest stage 1, at which the cable extends furthest from the sheath.
Put the lowest part of cable (39) into the small hook (figure A1). Pull it
until the small hook get in higher position (A2) and then insert the ca-
ble (39) onto the bracket (35) (figure A3).
5. Put one spring washer (32) and one curved washer (31) on each
screw (33). Push the screws (33) through the holes in the support (30),
screw into the threaded holes of the main frame (40) and tighten light-
ly.
6. Push the plastic cover (101) and rubber ring (100) into the right
position to cover the connection point.
STEP 4:
Installation of handgrips (5), footrest holder (44) and connecting tubes (25).
1. Push the handgrip bars (5R) onto the connecting tubes (25R) and adjust
the holes in the tubes so that they are aligned. (Note: the handgrip bars must
be aligned after assembly so that the upper ends are inclined outwards (away
from the support (30)).
2. Push the screws (33) through the holes and tighten the handgrip bars (5)
with curved washers (31) and spring washer (32) firmly.
3. Put the footrest holder (44R) at the connecting tube (25R) and adjust the
holes in the tubes so that they are aligned.
4. Push the screw M8x78 (23) through the holes and tighten the footrest
holder (44R) at connection tube (25R) with washers (27) and nut (26) firmly.
(This connection point has to move easily. So please don't tighten the screw
too much.)
5. Place the preassembled unit of the right footrest holder (44R) and con-
necting tube (25R) at the right hand side of the main frame (40). (Note: Right
is specified as viewed standing on the machine during training.)
6. Push the grip axle (19) into the middle
position at handlebar support (30) and put
one wave washer (20) and the connecting
tube (25R) onto the axles' end (19). Put on
the hex screw M8x20 (12) a spring washer
(32) and a washer 8//32 (22) and tighten it
firmly.
7. Put the foot pedal holder (44R) at the
pedal crank (97) and tighten them with steel
tube (52), washer 8//20 (49), spring washer
(32) and screw M8x20 (48) firmly.
8. Install the left footrest holder (44L) incl.
all additionally required parts on the left
hand side of the machine as described in 1.
– 7.
9. Put the plugs of pulse cables (10) into
the plugs from pulse connection cables (16)
and attach the screw caps (11) onto screws
(12).
15
GB