CARLO GAVAZZI WM50 Serie Manuel D'instructions page 34

Checking accessory module enabling
You can check whether modules are enabled from WM50 settings menu in sub-menu Modules. "Auto" means that the module is
automatically recognized and its status can no longer be changed.
Configure TCD12s
Configure TCD12 layout connected to WM50
Note: function only available via UCS.
1. Meet all the requirements indicated in "Configuration requirements via UCS" on page 28.
2. Start UCS.
3. Follow the instructions depending on how you want to configure:
If...
you want to create an offline configuration
you want to directly change settings
4. Select the layout that represents the physical TCD12 positions.
5. Select TCD12s connected to port A (TCD A bus) and those connected to port B (TCD B bus) in the order they are connected
to WM50 (i.e.: A1 for TCD A bus TCD12 closest to WM50).
6. Assign a channel group to each TCD12: group 1-12 is assigned to the first selected, group 13-24 to the second and so on.
7. Select each TCD12:
rotate it or reverse the channel order, if necessary (by default, the first channel is the one identified on TCD12, see
o
"TCD12" on page 27).
check/assign the correct phase to each channel.
o
optional. Create load groups.
o
8. Save changes.
9. If necessary, download the configuration on WM50 and check settings, see "TCD12" on page 6 and "Troubleshooting" on
page 36.
Moving a TCD12
If TCD12 position on the TCD bus changes, the system recognizes it: from UCS, view the warning on the involved TCD12. The
configuration must be reset accordingly.
Replacing a TCD12
If a TCD12 is replaced, the system indicates that the newly connected TCD12 is not expected and the BCM LED blinks on the
main unit. The configuration must be reset: the system will associate the physical position serial number and channel group that
used to be associated with the replaced TCD12 to the new one.
Then...
1. Create an offline configuration.
2. Open TCD12 settings.
1. Connect to WM50.
2. Open TCD12 settings.
WM50 - Instruction manual | 26/04/2022 | CARLO GAVAZZI Controls SpA
Configure the system
33