CARLO GAVAZZI WM50 Serie Manuel D'instructions page 33

Configure the system
Page
title/sub- Page title
menu
Meters Total
Partial
Total +
Total -
Partial +
Partial -
Tariff
Heating
Trip
Reset Reset max
Reset DMD
Reset DMax
Reset MIN
Clock Format
Year
Month
Day
Hour
Minute
Second
End -
Accessory modules settings
Accessory module
M A TPN
M F I6 06
M F I6 R4
M C 485 232
M C ETH
Running a pulse transmission test
Note: function only available from WM50.
If a digital output is configured as a pulse output, a pulse transmission test can be run.
1. In the settings menu, open the Dig out x sub-menu (where x is the concerned digital output).
2. Ensure that the output is configured for pulse transmission (Function = Puls).
3. Define the pulse weight (Pulse weig) and test power (Power test).
4. To start the test, in the Out test page, set Yes.
5. Exit the Dig out x sub-menu and scroll settings to the End page and confirm exit: the test starts.
6. To end the test, open the Dig out x sub-menu, Out test page and set No.
32 WM50 - Instruction manual | 26/04/2022 | CARLO GAVAZZI Controls SpA
Description
Resets main line total energy meters Yes : resets values/ No : no action
Resets partial energy meters
Resets total positive energy meters
Resets total negative energy meters
Resets partial positive energy meters
Resets partial negative energy
meters
Resets tariff energy meters
Resets C1, C2, C3 pulse totalizers
with Puls function
Resets C1 totalizer with protection
trip function
Resets maximum values
Resets DMD values
Resets Max DMD values
Resets minimum values
Time format
Year
Month
Day
Hour
Minute
Second
Saves changes and returns to
measurement menu
Sub-menu/Page
Ct ratio
Process
Dig in x
Dig out x
RS485232
Ethernet
Values
Yes : resets values/ No : no action
Eu: European
uSA: American
Up to 2099
From 1 to 12
From 1 to 31
From 0 to 23
From 0 to 59
From 0 to 59
-