Anti-Masking Alarm - SORHEA KAPIRIS III Notice D'installation

SORHEA
Reactivate the 2 sensors (PIR and MW) by unchecking "Deactivate PIR sensor," then select "Send."
Re-conduct the passages in the established zone.
Audio and visual indicators
No beep
Red LED not on
Slow beeping
Red LED blinks slowly
Rapid beeping
Red LED blinks rapidly
Continual beeping
Red LED lit continually
Re-enter detection mode by turning switch 1 to OFF.
Repeat a test to confirm that an alarm is triggered. If no alarm is triggered, repeat the adjustment
procedure.
Remove the Ethernet connector and turn switch 2 to OFF.
Replace the cover.

8.2 Anti-masking alarm

The alarm is triggered when an obstruction is
placed against the anti-masking sensor located
in the bottom part of the PIR filter.
(the anti-masking alarm is triggered about 30
sec. after the placement of an obstruction)
Note: the anti-masking alarm can be deactivated by
unchecking "Activate anti-masking. The anti-
masking relay is by default in alarm mode.
The anti-masking
alarm is
deactivated.
Detection status
No detection
Detection of subject by the
MW sensor only
Detection of subject by the MW
sensor and the PIR sensor
Alarm
Anti-masking sensor
The anti-masking relay is in alarm status.
- 47 -
KAPIRIS III