Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SORHEA
Adjustment requires 2 steps:
1. Adjusting PIR
2. Adjusting the Microwave (MW)
3.1) Adjusting PIR
Deactivate MW by checking "Deactivate MW sensor," then select ("Send").
Deactivation of MW
Send
Establish the desired detection zone for the PIR sensor by making passages in this zone. Adjust the
sensor vertically and horizontally until the correct position is obtained.
An alarm is triggered when the red LED is lit constantly accompanied by a long, continual beep.
Audio and visual indicator
No beeping
Red LED not on
Continual beeping
Red LED lit continually
Detection status
No detection
Alarm
- 43 -
KAPIRIS III
Publicité
Chapitres
Table des Matières
