SORHEA
Step 2:
Connect the PC to the sensor.
Step 3:
2) Turn the sensor on and check to make sure the red LED is lit continually (without blinking).
This indicator light should remain lit until the installation is completed (minimum time 30 sec.)
Do not move in the detection zone to avoid interfering with the installation of the sensor.
Step 4:
Put switch 2 into the ON position to activate the Ethernet connection.
7.3 Connection to KAPIRIS III
Step 1:
Check to make sure that your computer is connected to the local area network
Switch 1 is OFF and
Switch 2 is ON
- 39 -
KAPIRIS III