Working Without The Automatic Leveller; With The Clamp Tripod; Cleaning - Parkside PKLL 7 B2 Traduction Des Instructions D'origine

All manuals and user guides at all-guides.com
GB IE NI
4. Switch the device off by
locking the levelling stop:
position .
In the event of vibrations,
the laser will level itself auto-
matically; wait until the laser
lines no longer move.
Working without the
automatic leveller
Caution! - Laser beam.
Do not look into the
away or close your eyes
to prevent looking into the
laser beam.
Danger of eye injury!
minate permanently in red
when working without the
ser lines depicted are not
levelled.
Switching on:
1
(4) must be in position
Switching off:
off switch (1).
Working with the clamp
tripod
be used to attach the device to
various objects.
8
2 -
-
.
1. Release the clamping nut
(9).
2. Position the clamping jaws
(10) to the desired location.
3
until fastened.
4. Place the device with thread
(5) onto the tripod screw (7)
and tighten by hand.
Do not use excessive force
as this may damage the de-
vice.
release the retaining screw
(8) and move the device into
the desired position.
6. Fix the position by fastening
the retaining screw (8).
Working with the tripod
You can place the device in a
stable position and adjust the
height using a tripod (not provi-
ded in scope of delivery).
Place the device with thread (5)
onto the tripod screw and tigh-
ten by hand.
Do not use excessive force as
this may damage the device.

Cleaning

Have any work on
the device that is
not described in this
instruction guide
performed by a pro-
fessional. Only use
original parts.