Switching The Infrared Controller; Dimming Function For The Infrared Heater/Infrared Plate; Seat Sensor (Optional) - Sentiotec Infrabox basic S set Instructions Pour L'installation

Instructions for use for the user
WARNING!
Risk of fire
● Before the infrared controller is switched on, make sure that no flam-
mable objects have been hung over the infrared heater or on the
infrared plate.

8.2. Switching the infrared controller

1. Press the ON/OFF switch 3, to switch on the infrared controller.
► The operating display 4 goes on.
2. Select the intensity of the function with the intensity selector 1 and 2 the
required intensity of the function.
► The infrared heater/the infrared plate begins to heat up.

8.3. Dimming function for the infrared heater/infrared plate

Controlling (dimming) the infrared heater/infrared plate is possible in 5 levels.
At 0 the infrared heater/infrared plate is switched off, at 5 it is a full capacity.
Function only possible in operating modes: leading edge phase control and
half-wave control
To activate the function, additional settings are required, see chapter 6.2. Operat-
ing type (infrared heater/infrared plate) on page 20.
Function only possible in operating mode: normal and seat
To activate the function, additional settings are required, see chapter 6.1. Oper-
ating mode on page 19.
1. Use the intensity selector 1 and 2 the preferred infrared heater/infrared
plate intensity.
► The infrared heater/infrared plate is switched on.
► The intensity display 5 lights up.

8.4. Seat sensor (optional)

When using a seat sensor (available as an option), the infrared output for the
set seat time switches on automatically if you have set it previously. The infra-
red control unit must be switched on to do so (see 8.2 Switching on the infrared
control unit)
p. 29/32
EN