Ryobi QUIETSTRIKE P290 Manuel D'utilisation page 7

DRIVING OR REMOVING SCREWS
See Figures 5 - 6, page 9.
WARNING:
Do not drive a screw where there is likely to be hidden
wiring behind the surface. Contact with a "live" wire will
make exposed metal parts of the tool "live" and shock
the operator. If you must drive a screw where hidden wire
could be present, always hold tool by insulated gripping
surfaces (handle) when performing the operation to
prevent a shock to the operator.
OPERATION
MAINTENANCE INFORMATION
BEGINS ON PAGE 8, AFTER FRENCH AND
SPANISH LANGUAGE SECTIONS.
ILLUSTRATIONS BEGIN ON PAGE 9.
NOTICE:
The impact driver is not designed to be used as a drill.
 Place the direction of rotation selector in the correct
position for operation.
 Hold the impact driver with one hand.
 Place the bit on the screw head and slowly depress the
switch trigger. Start the bit slowly for more control.
NOTE: The Tri-Beam LED will illuminate as the trigger is
depressed.
 As the screw is driven, impacting will begin.
NOTE:
7 — English