Johnson Outdoors TALON 1810302 Mode D'emploi page 8

4
i. Next the Talon should be installed on the Mounting
Bracket. Take the Talon and notice that there is an
Assembly Track located on both sides of the Talon.
NOTICE:
We recommend a second person to help
with this step of the installation.
j. Carefully lift the Talon into the Mounting Bracket
and align the Mounting Straps with the Assembly
Track. Slide the Guard Washers to the inside wall of
the Mounting Bracket, so that they sit between it and
the Talon Assembly. Slide the Talon Assembly down
the Assembly Tracks until it comes in contact with
the Vertical Stop Bolt.
NOTICE:
If the Talon was previously installed, the
Water Deflection Shield may need to be removed
and reinstalled after the Talon is secure. Refer to the
Talon Owners Manual on how to install the shield.
5
k. While supporting the Talon, adjust it and the
Vertical Stop Bolt up or down in the Mounting
Bracket so that the bottom of the Talon is not less
than 4 inches above the Bottom of the hull of the
boat, or the waterline of the boat. Once in place,
temporarily tighten the Vertical Stop Bolt.
l. Double check the placement of the Talon and make
sure it meets all of the mounting considerations.
Make any adjustments as necessary. When the
position of the Talon is acceptable, secure the four
Hex Head Cap Screws and Nylock Nuts holding the
Mounting Straps in place with a 9/16" Box End or
Socket Wrench. Use a torque wrench to tighten to a
recommended torque of 20 to 30 ft-lbs. Tighten the
Vertical Stop Bolt.
NOTICE:
Additional adjustments may need to be
made to the mount after a trial run with the boat on
the water. Periodically re-tighten the four nuts and
screws to 20 to 30 ft-lbs.
For warranty information, please visit
minnkotamotors.com
Part #2374946
minnkotamotors.com.
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
4i
Talon
Assembly
Track
Assembly
Track
Mounting
Straps
4j
Talon
Vertical
Stop Bolt
Mounting
Bracket
Assembly
Track
Talon Talon
Assembly Assembly
Mounting Mounting
Bracket Bracket
4" Minimum 4" Minimum
Hull directly
below Talon
CAUTION
Check tension of the 4 vertical adjustment nuts after initial
use and periodically thereafter to ensure they are at the
recommended torque of 20 to 30 ft-lbs.
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
ECN 40106
4j
Talon
Mounting
Strap
Assembly
Track
Mounting
Bracket
Vertical Vertical
Stop Bolt Stop Bolt
Hex Head Hex Head
Cap Screws Cap Screws
Bottom Edge Bottom Edge
of Talon of Talon
©2019 Johnson Outdoors Marine Electronics, Inc.
Rev C
Hull
All rights reserved.
09/19