Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.
The Adapter Bracket can be purchased to accommodate for
either a Port or Starboard installation. If an Adapter Bracket
is installed to both the Port and Starboard side, the Shim
Brackets will not be used and will be replaced with the Elbow
Bracket for that side. If the boat is to be rigged that way, it may
be necessary to remove a factory equipped e-ladder for proper
bracket installation. Due to the wide variety of e-ladders, Minn Kota is not responsible for the re-installation or re-location of any
factory equipped e-ladder.
3.
The Adapter Bracket can be mounted in 3 possible ways: a. between the Jack Plate and Transom b. between the Outboard and Jack
Plate or c. between the Outboard and Transom. The mounting instructions are described below and will be similar for all installation
methods or Jack Plate offset distances.
2
Starboard
4.
The Shim Plate should be orientated so that the Mounting Holes mirror the holes in the Elbow Bracket from the centerline of the boat.
Which Mounting Holes on the Elbow Bracket and the Shim Plate used will depend on the Outboard motor installed. The flat edge of the
Elbow Bracket should face downward.
Correct
NOTICE:
The Outboard does not have to be completely
removed. Remove the mounting bolts that secure the
Outboard to the Transom from one side and loosen the
mounting bolts on the opposite side. Tilt the Outboard
motor for the installation steps below. Repeat for the
opposite side to complete the installation.
NOTICE:
These installation steps switch between a
starboard and port installation and are for reference only.
They may differ from your actual installation.
NOTICE:
Check with your Jack Plate or Outboard manufacturer to determine if additional hardware is needed to accommodate
installing this Adapter Bracket.
2 | minnkotamotors.com
2
Port
Incorrect
NOTICE:
will be included. The Bracket selected will be dependent on
if a Port or Starboard installation was selected. Additional
Talon Adapter Brackets must be purchased separately.
3a
Jack Plate
Outboard
Transom
Complete Typical Installation
Only one Elbow Bracket (Item #2 or Item #4)
3b
Transom
Outboard
Jack Plate
Incorrect
©2019 Johnson Outdoors Marine Electronics, Inc.
3c
Transom
Outboard
Publicité
Table des Matières
