Johnson Outdoors TALON 1810302 Mode D'emploi page 3

INSTALLATION
Installation without Jack Plate
1
ITEM(S) NEEDED
NOTICE:
The Outboard doesn't have to be
completely removed. Remove the two mounting
bolts from one side and loosen the mounting bolts
on the opposite side. Tilt the Outboard motor for
the installation steps below. Repeat for opposite
side to complete installation.
a. Support the Outboard and remove the hardware
that attaches the Outboard to the boat Transom.
Determine if the Adapter Bracket purchased is
installed on the Port or Starboard side.
b. Take the Elbow Bracket (Item #2 or Item #4) and
the Shim Plate (Item #10) if needed, and apply
marine grade silicon to all of the transom-side
Mounting Holes the bracket. The Brackets selected
will be dependent on a Port or Starboard mount for
each individual installation.
2
c. Install the Elbow Bracket and Shim Plate between
the Outboard and the Transom. Use the hardware
that was already on the boat to install the bracket
and plate. Reinstall the mounting hardware
loosely using the Mounting Holes that align with
the existing hardware. The hardware should pass
through the Outboard, the Talon Adapter Bracket
and the Transom of the boat.
d. Once the Elbow Bracket and Shim Plate are
positioned, tighten and torque the mounting
hardware to the boat and/or outboard manufacturer's
specifications. Continue to the "Completing the
Installation" section of these instructions.
3 | minnkotamotors.com
#2 x 1 #4 x 1
1b
#10 x 1
1a
Transom Transom
Elbow Elbow
Bracket Bracket
Mounting Mounting
Port Port
Transom Transom
Elbow Elbow
Bracket Bracket
Port Port
Shim Shim
Mounting Mounting
Holes Holes
Holes Holes
Starboard Starboard
Outboard Outboard
Shim Shim
Starboard Starboard
©2019 Johnson Outdoors Marine Electronics, Inc.