Johnson Outdoors TALON 1810302 Mode D'emploi page 5

Installation Between Jack Plate and Outboard
1
ITEM(S) NEEDED
NOTICE:
The Outboard doesn't have to be
completely removed. Remove the two mounting
bolts from one side and loosen the mounting bolts
on the opposite side. Tilt the Outboard motor for
the installation steps below. Repeat for opposite
side to complete installation.
a. Support the Outboard and remove the hardware
that attaches the Outboard to the boat Jack Plate.
Determine if the Adapter Bracket purchased is
installed on the Port or Starboard side.
b. Take the Bracket Elbow (Item #2 or Item #4)
and the Shim Plate (Item #10) if needed, and
determine the mounting location. The Brackets
selected will be dependent on a Port or Starboard
mount for each individual installation.
2
c. Use the hardware that was already on the boat to
install the Elbow Bracket and Shim. Reinstall the
mounting hardware loosely. The hardware should
pass through the Outboard, the Talon Adapter
Bracket and the Jack Plate.
d. Once the Elbow Bracket and Shim Bracket are
positioned, tighten and torque the mounting
hardware to the boat and/or outboard manufacturer's
specifications. Continue to the "Completing the
Installation" section of these instructions.
5 | minnkotamotors.com
#2 x 1 #4 x 1 #10 x 1
1a
Transom Transom
Jack Jack
Plate Plate
Elbow Elbow
Bracket Bracket
Port Port
NOTICE:
This installation method is NOT compatible
with Atlas Jack Plates (all offsets). Installation with Bob's
Machine Shop Jack Plates will require Spacer Block Kit
#1810211.
1b
Transom Transom
Jack Plate Jack Plate
Elbow Elbow
Bracket Bracket
Outboard Outboard
Spacer Block Kit Spacer Block Kit
#1810211 #1810211
(if needed) (if needed)
Shim Shim
Starboard Starboard
Outboard Outboard
Shim Shim
©2019 Johnson Outdoors Marine Electronics, Inc.