Stihl HS 81 Notice D'emploi page 23

English
5
: Carefully remove the rope rotor (4)
with pawl (5).
: Use a screwdriver to pry the rope
out of the starter grip.
: Remove the remaining rope from
the rotor and grip.
: Thread the new rope through the
starter grip and tie one of the special
knots shown.
: Pull the knot back into the grip.
22
All manuals and user guides at all-guides.com
: Thread the rope through the top of
the guide bushing (6).
: Pull the starter rope through the
rotor (7) and secure it with a simple
overhand knot.
: Coat rope rotor bearing bore with
non-resinous oil.
: Fit the rotor on the starter post (8) –
turn it back and forth to engage the
anchor loop of the rewind spring.
5
: Refit the pawl (5) in the rotor (4).
: Install the spring clip (3) on the
starter post and engage it on the
pawl's peg.
HS 81 R, HS 81 T