Milk Circuit Wash Cycle - Saeco PRIMEA Touch Plus Mode D'emploi

mILK CIRCUIT WASH CYCLE

WARNINg! DO NOT OPEN THE SERVICE DOOR DURINg THE bREWINg, DISPENSINg, WASHINg
OR RINSE CYCLE.
To wash the machine's internal circuits used for preparing milk.
This cycle is proposed after 14 days from the fi rst dispensing of a milk-based beverage. After 14 days, the "milk
cleaning" message starts fl ashing (see page 14). Perform the wash cycle as described in this section.
Push the "milk cleaning" button and refer to the instructions below, at step 2. The machine switches to the status
described at point 7.
If the milk circuit wash cycle is not performed after 14 days, the dispensing of milk-based beverages will be still
possible for only 7 more days. After 7 days, the wash cycle must be performed because the dispensing of milk-based
beverages is disabled. (The machine still enables dispensing hot water and coffee).
To remind the user of this important operation, the message "milk cleaning -3" is shown on the display 3 days before
the deadline and is updated on subsequent days.
before performing this function make sure that:
1. a large enough container is at hand.
2. the milk container has been adequately cleaned of all milk residue.
3. the water tank contains a suffi cient quantity of water.
THE WASH CYCLE CANNOT bE INTERRUPTED. A PERSON mUST bE PRESENT DURINg THE OPERATION.
USE ONLY THE PROVIDED mILK CLEANINg DETERgENT.
1
coffee
lock
cleaning
display
cycle
milk
maintenance
cleaning
cycle
milk circuit
descaling
rinsing
cycle
cycle
back to
go back
menu
Select the function by
pressing the "milk cleaning
cycle" icon.
All manuals and user guides at all-guides.com
program-
milk
show icon my custom
ming
explanation cleaning coffee
menu
milk
program-
show icon my custom
cleaning
ming
explanation coffee
-3 menu
2
open the compartment and
remove the milk container.
29
3
insert the contents of the
detergent packet into the
container.