Installation - Harmony DASH Manuel D'instructions

! DO NOT position vehicle belt over top of the armrests ❻.
! DO NOT use any load bearing contact points other
than those described in the instructions and marked in
the child restraint.
IF IN DOUBT ABOUT THESE POINTS OR ANY
QUESTIONS RELATED TO INSTALLATION, PLEASE
CONTACT HARMONY JUVENILE PRODUCTS.
DUE TO VARYING ANGLES OF VEHICLE SEAT BELT
RETRACTORS, EXCESS SLACK IN THE VEHICLE BELT
SYSTEM MIGHT NOT BE REMOVED AUTOMATICALLY.
Once the lap and shoulder portions of the seat belt
are properly positioned and the buckle is attached,
FEED ANY REMAINING SLACK OF THE SEAT BELT
MANUALLY BACK INTO THE RETRACTOR TO TIGHTEN
THE WHOLE SYSTEM.
1. Place the booster seat flush against a forward-facing
vehicle seat. The vehicle seat MUST be equipped with
a 3-point lap-and-shoulder belt. Booster must be
level, stable and not rock side-to-side (see "Vehicle
seating positions").
2. Place child on the booster seat with child's back flat
against the vehicle seat.
3. Thread both sides of the lap
belt under BOTH
armrests.
the lower end of
the shoulder belt
under the armrest
on the buckle side
❶. ENSURE that the belt is
snug across the child's hips. It is
important to ensure that any lap

INSTALLATION

WARNING!
!
Thread
❶
18