Sony SU-WL450 Informations D'installation page 15

3
Preventing the bottom of the TV
or LCD Monitor from shifting.
• Take up the slack of Belt  and attach it
to the wall tightly.
2-a
 Belt
• Use a 5 mm diameter screw or equivalent
(not supplied).
Note
 Try to pull the bottom of the TV or LCD Monitor
towards yourself slightly, to make sure that it does
not move forward. If there is any movement, it is
not fixed correctly, and the Belt  should be
secured firmly again.
Except KD-85X8xK / 85X8xAK /
85X8xTK / 75X8xK / 75X8xBK /
75X8xDK / 75X8xSK / 75X8xTK,
KM-85X8xK / 75X8xK, XR-85X9xK /
75X9xK, XRM-85X9xK / 75X9xK
WARNING
 Two or more persons (three or more persons for
189.3 cm (75 inches) and above TV or LCD Monitor) are
needed to transport a large TV or LCD Monitor (except
Egypt).
Two or more persons (three or more persons for
75 inches (189.3 cm) and above TV or LCD Monitor) are
needed to transport a large TV or LCD Monitor (Egypt
only).
1
2-b
 Belt
2
− 15 (GB) −
Lift the TV or LCD Monitor.
• For the location of the Pulleys  to hang
on the Base (20)  or Base Adaptor ,
refer to "Base Adapter  fitting location"
on page 20.
• Make sure that the rear of the TV or LCD
Monitor touches the Base (20)  or Base
Adaptor  when holding the TV or LCD
Monitor.
 Pulley
Note
 Hold the TV or LCD Monitor securely with both
hands.
Install the TV or LCD Monitor
onto the Base (20)  or Base
Adaptor .
• Gently slide down the TV or LCD Monitor
and hang the Pulleys  attached to the
rear of the TV or LCD Monitor to the Base
(20)  or Base Adaptor , making sure
to confirm the shape of the holes.
• After installing the TV or LCD Monitor on
the wall, confirm the Pulleys  are firmly
latched into the Base (20)  or Base
Adaptor .
• Release both hands slowly to ensure that
the TV or LCD Monitor does not fall.
GB