Bosch GKS 36 V-LI Professional Notice Originale page 25

All manuals and user guides at all-guides.com
OBJ_BUCH-304-004.book Page 25 Wednesday, February 20, 2008 10:08 AM
To remove the battery 6:
– Push the battery against the base of the pow-
er tool (1.) and at the same time press the
battery unlocking button 5 (2.).
– Pull the battery out of the power tool until a
red stripe becomes visible (3.).
– Press the battery unlocking button 5 again
and pull out the battery completely.
Battery Charge-control Indication
(see figure B)
The three green LEDs of the battery charge-con-
trol indicator 27 indicate the charge condition of
the battery 6. For safety reasons, it is only pos-
sible to check the status of the charge condition
when the machine is at a standstill.
Push button 26 to indicate the charge condition
(also possible when the battery is removed).
The battery charge-control indicator automati-
cally goes out after approx. 5 seconds.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
When no LED lights up after pushing button 26,
then the battery is defective and must be re-
placed.
During the charging procedure, the three green
LEDs light up one after the other and briefly go
out. The battery is fully charged when the three
green LEDs light up continuously. The three
LEDs go out again approx. 5 minutes after the
battery has been fully charged.
Bosch Power Tools
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
Mounting/Replacing the Saw Blade
Before any work on the power tool, remove
the battery.
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Only use saw blades that correspond with
the characteristic data given in the operat-
ing instructions.
Do not under any circumstances use grind-
ing discs as the cutting tool.
Selecting a Saw Blade
An overview of recommended saw blades can
be found at the end of this manual.
Removal of the Saw Blade (see figure A)
For changing the cutting tool, it is best to place
the machine on the face side of the motor hous-
ing.
– Press the spindle lock button 17 and keep it
pressed.
The spindle lock button 17 may be actuated
Capacity
only when the saw spindle is at a standstill.
≥2/3 Otherwise, the power tool can be damaged.
– With the Allen key 19, unscrew the clamping
≥1/3
bolt 24 turning in rotation direction
<1/3
– Tilt back the retracting blade guard 10 and
Reserve
hold firmly.
– Remove the clamping flange 23 and the saw
blade 22 from the saw spindle 20.
Mounting the Saw Blade (see figure A)
For changing the cutting tool, it is best to place
the machine on the face side of the motor hous-
ing.
– Clean the saw blade 22 and all clamping
parts to be assembled.
– Tilt back the retracting blade guard 10 and
hold firmly.
English | 25
.
1 609 929 P97 | (20.2.08)