Out / Adjustment Conditions; Analogue Output A - Rechner Sensors i-Level+ Notice D'utilisation

Analogue Output A

The probe is supplied without any presetting.
The probe needs 2 seconds for initialization when power is switched on. During initialization the analogue
output is A = 4 mA (0 V) or with the reverse output model 20 mA (10 V).
OUT
During the adjustment the output A
Output characteristics (Values for voltage output version in brackets):
A = 4 mA (0 V)
OUT
A = 8 mA (2,5 V)
OUT
A = 12 mA (5 V)
OUT
A = 16 mA (7,5 V)
OUT
A = 20 mA (10 V)
OUT
= 4 - 20 mA (0 - 10 V) variable a T he analogue output reacts to the measured filling level
A
OUT
Capacitive input
95%
0%
t
D
Output dead time (t ) =50 ms
D
Output reaction time (t
Adjustment conditions
1. Please note that the first adjusted level determines the lowest filling level that can be measured at the
measuring range. That means the next adjustment can only be above the level that has been adjusted
first.
2. The full adjustment with „Analogue Max" only can be made when „Analog Min" has already been set.
3. The filling level for „Analog Max" cannot be lower than „Analog Min".
4. With re-adjustment of „Analog Min" the stored value for „Analog Max" will be automatically cancelled.
22
OUT
is inactive and will not react on changes of the filling level.
OUT
a n o adjustment or unsuccessful adjustment (Error!)
a A NALOG MIN adjustment active
a A NALOG MIN adjustment okay
a A NALOG MAX adjustment active
a A NALOG MAX adjustment okay
A
OUT
t
time
R
)= 950 ms
R
Capacitive input
100%
5%
t
D
A
OUT
t
time
R