Black & Decker CLM3825 Mode D'emploi page 12

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
ENGLISH
box (9) over the lugs (20).
Your mower features the BLACK+DECKER Easy - height adjust -
ment system. This system will adjust all four wheels at the
same time.
The mower has six blade height adjustment positions (30 mm
to 80 mm). Refer to the scale on the side of the mower. The
pointer will indicate the height setting for cutting your lawn.
This setting can be a reference for the next time you want to
cut your lawn to the same height.
Release the bail bar (2) to turn the lawnmower off, wait
until the blade stops and remove the safety key (1).
To raise or lower the cutting height, place the palm of your
hand on the palm rest (21) and pull the height adjustment
lever (13) away from the mower body.
Move the height adjust lever (13) into the required position
then push it back in towards the mower body.
Make sure that the mower is securely locked in one of
the six positions.
Place the mower on level ground.
Release the bail bar (2) to turn the mower off, wait for the
blade to stop and remove the safety key (1).
Pull the battery cover release (15) towards the front of the
mower body and lift the battery cover (14).
Lift the battery (22) out of the mower.
Pull the battery cover release (15) towards the front of the
mower body and lift the battery cover (14).
Slide the battery (22) into the mower. (the battery will only
Let the appliance work at its own pace. Do not
overload.
done before. The battery may become warm while charging;
this is normal and does not indicate a problem.
Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging tem-
perature: approx. 24 °C.
To charge the battery (22), insert it into the charger (23).
not force. Be sure that the battery is fully seated in the
charger.
Plug in the charger and switch on at the mains.
(Original instructions)
(slowly).
The charge is complete when the charging indicator (24)
lights green continuously. The charger and the battery can be
occasionally tops off the battery charge. The charging indica-
tor (24) will be lit as long as the battery is connected to the
plugged-in charger.
Charge discharged batteries within 1 week. Battery life will
be greatly diminished if stored in a discharged state.
The charger and battery pack can be left connected with the
pack fresh and fully charged.
If the charger detects a weak or damaged battery, the charg-
follows:
Re-insert the battery (22).
rate, use a different battery to determine if the charging
process works properly.
If the replaced battery charges correctly, the original bat-
tery is defective and should be returned to a service centre
for recycling.
If the new battery gives the same indication as the original
battery, take the charger to be tested at an authorised
services centre.
be used to display the current level of charge in the battery
during use and during charging.
Press the state of charge indicator button (25).
Remove the safety key:
Whenever leaving the appliance unattended.
-
Before cleaning a blockage.
Before checking, cleaning or working on the appliance.
After striking a foreign object.
Whenever the appliance starts vibrating abnormally.
Sharp moving blade. Never attempt to override the
operation of this switch and safety key system as a serious
injury could result.
Insert the safety key (1) fully into the switch housing.
Push the lock off release button (3) on the top of the
switch housing.
Pull the blade bail bar (2) toward the handle bar (4).

Publicité

Table des Matières
loading

Table des Matières