Cleaning And Maintenance; Travel Lock - Nevadent NAZ 2.4 C3 Mode D'emploi

All manuals and user guides at all-guides.com

Cleaning and maintenance

DANGER – RISK OF ELECTRIC SHOCK!
► Always remove the plug from the charger 8 before cleaning the appli-
ance!
Do not immerse the handset or the charger 8 in water or other
liquids!
CAUTION – PROPERTY DAMAGE!
► Do not use detergents or solvents . They can damage the plastic surfaces .
NOTE
NEVER open the housing of the charger 8 or the toothbrush! They
cannot be resealed in a watertight manner .
1) Unplug the charger 8 from the power socket .
2) Clean the charger 8 inside and out with a soft, lightly moistened cloth .
3) Remove the brush head 1 from the handset . After use, clean the brush
heads 1 thoroughly under running water .
We recommend cleaning the brush heads 1 in a standard commercial den-
ture cleaning fluid every 2–4 weeks . A new brush head 1 should be fitted
after about 3 months, and the brush head must always be replaced when
the bristles start to bend outwards .
4) To clean the drive shaft 2 and the handset, hold them under running water
for a short while . Hold the handset so that the drive shaft 2 is pointing down-
wards at an angle .

Travel lock

This toothbrush is equipped with a travel lock
button 3 to prevent accidental starting of the toothbrush:
Press and hold the On/Off button 3 until the charge indicator 7 flashes green
5 times .
The On/Off button 3 is now locked .
To unlock the switch, press and hold the On/Off button 3 until the charge
indicator 7 lights up once for a few seconds .
NOTE
► If you try to switch on the toothbrush while the travel lock is activated, the
charge indicator 7 will flash 5 times . The toothbrush will not start .
NAZ 2.4 C3
. You can lock the On/Off
GB │ IE │
23 ■