Cleaning And Care - Nevadent NSZB 3.7 B2 Mode D'emploi

7) After 30 seconds, the toothbrush stops briefly to signal that you should
start cleaning the next quadrant. Clean each jaw quadrant using the same
technique.
8) After two minutes, the toothbrush stops briefly 2 times. This informs you
that you have complied with the dental recommendation of two minutes
cleaning.
9) Press the on/off switch
10) Then take the toothbrush out of your mouth.
11) After use, rinse the brush head
12) Remove the brush head
To clean the drive shaft
ter for a short while. Hold the handset so that the drive shaft
downwards at an angle.
NOTE
Massage your gums regularly. This promotes blood circulation and helps to
keep them healthy. Set the mode to "Pulse" and guide the moistened brush
over your gums with a light pressure.

Cleaning and care

DANGER – RISK OF ELECTRICAL SHOCK!
► Always remove the plug of the charger
cleaning the appliance! There is a risk of electric shock!
Do not immerse the handset or the charger
WARNING – PROPERTY DAMAGE!
► Do not use detergents or solvents. They can damage the plastic surfaces.
NOTE
Never open the housing of the charger
resealed in a watertight manner.
1) Dismantle the charger
–
Hold the lower part of the charger
contains the brush holders
2) Clean the upper part of the charger
paste residue in the brush holders
of the charger
3) Clean the lower part of the charger
cloth.
4) Remove the brush head
heads thoroughly under running water.
We recommend cleaning the brush heads
denture cleaning fluid every 2 - 4 weeks. A new brush head
be used after about 3 months, at the latest when the bristles start to bend
outwards.
5) To clean the drive shaft
for a short while. Hold the handset so that the drive shaft
downwards at an angle.
■ 26 │
GB
repeatedly until the toothbrush stops.
from the handset.
and the handset, hold them under running wa-
for cleaning:
, towards the rear.
in warm water and then rinse out the brush holders
from the handset. After use, clean the brush
and the handset, hold them under running water
thoroughly under running water.
from the power socket before
in water or other liquids!
or the toothbrush! They cannot be
firmly and tilt the top part, which
under running water. If any tooth-
cannot be removed, soak the upper part
only with a soft, slightly damp
in a standard commercial
is pointing
.
should
is pointing
NSZB 3.7 B2