Setting Up; First Use; Fitting / Removing Brush Heads - Nevadent NSZB 3.7 B2 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Setting up

NOTE
In damp rooms, especially in the vicinity of water (bath), the charger
must be set up so that it cannot accidentally fall into the water.
1) Place the charger
Ensure that the charger

First use

NOTE
Before starting to use the appliance, check that it is in fault-free condition.
You must not use the appliance if it has any faults.
1) Insert the power plug into the socket.
2) Before initial use, clean the new brush heads
3) Open the lid
holders
. Close the lid
4) Place the handset on the charger
base.
5) Allow the handset to charge for around 14–16 hours before using it for
the first time. The charge indicator
red during the charging process.
6) Use the handset repeatedly without charging the battery until the perfor-
mance becomes noticeably weaker or the toothbrush stops working and
the charge indicator
hours. When the appliance is fully charged, the charge indicator
up green.
7) Charge and discharge the toothbrush completely 3 times. At that point, the
battery will have reached its full capacity.
8) You can now leave the handset on the charger
always have full power available.

Fitting / removing brush heads

To remove the brush head
When fitting the brush head
slides precisely into the socket on the brush head
Push the brush head
NOTE
To avoid damage to the appliance, always use original brush heads.
(see section "Order replacement parts" for replacement brush heads)
You can also use the replacement brush heads of the model Oral B
Sonic Complete* for this appliance.
*Oral-B is a registered trademark of Procter & Gamble.
24 
GB
on a clean and level surface.
cannot fall into water, such as into a bath or sink.
and place the replacement brush heads into the brush
again.
flashes red. Then recharge the battery for 14 - 16
, pull it upwards and off the drive shaft
, ensure that the drive shaft
down until it completely covers the drive shaft
with fresh water.
so that it slides onto the pin on the
on the front of the handset lights up
after every use, so as to
.
lights
.
on the handset
.
©
NSZB 3.7 B2

Publicité

Table des Matières
loading

Table des Matières