Set-Up/Wall Bracket; First Use - Nevadent NAZ 2.4 B2 Mode D'emploi

CAUTION – PROPERTY DAMAGE!
The electric toothbrush may only be recharged with the supplied
►
charger. The appliance could otherwise be irreparably
damaged!
Only operate the appliance with the original accessories
►
supplied.

Set-up/wall bracket

NOTE
► The charger may only be operated free-
standing if used in dry rooms.
► In damp rooms, especially in the vicinity of
water (bath), the charger
fixed to the wall to protect it from falling into
water.
1) Pull the wall bracket
underneath the charger
2) Using the screw holes of the wall bracket
mark the spacing for the boreholes on the
wall. Check to ensure that there is a mains
power socket in close vicinity.
3) Before drilling the holes, check to ensure that
there are no electrical cables or water pipes
behind the markings.
4) Use a 5 mm drill bit to drill the required holes
and insert the supplied wall plugs.
5) Attach the wall bracket
provided.
■ 4 │ GB │ IE
must be firmly
downwards from
.
,
using the screws
6) After you have attached the wall bracket
push the charger
wall bracket . The mains cable should lie
in the middle. Guide the mains cable through
the right-hand or left-side recesses on the wall
bracket and then push the charger
the way onto the wall bracket
7) Ensure that the mains cable is not trapped
and that it lies properly in the recess.

First use

NOTE
Before starting to use the appliance, check that
it is in fault-free condition. If it is not, it must not
be used.
1) Insert the plug into the mains power socket.
2) Before initial use, clean the new brush heads
with fresh water.
3) Open the lid of the charger
the replacement brush heads on the brush
holders. Re-close the lid
4) Place the handset on the charger
it slides onto the pin on the base.
a short way onto the
all
.
and place
.
so that
NAZ 2.4 B2
,