Adjusting The Steam Quantity; Refilling Water; Turning Off The Appliance; Storing The Appliance - SilverCrest 37702 Instructions D'utilisation

Set de nettoyage vapeur
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
Note: You can cut down the heating-up time
by using warm water.
Screw the safety cap (A4) back onto the de-
vice.
Turning on the Appliance
Place the unit securely on a firm surface.
Caution
The appliance must not be carried during clean-
ing.
Insert the mains plug (A7) into a socket.
Both indicator lamps (A2/A3) must illumi-
nate.
Caution
Do not turn the appliance on without water in the
boiler. Otherwise, the appliance may overheat
(see Help with faults).
The orange indicator lamp (A3) goes out af-
ter approximately 8 minutes.
The steam cleaner is ready to use.
Push the steam switch lock (B3) to the back.
Note: If you push the lock forward, the steam
switch cannot be actuated (child control).
While operating the steam switch (B4), direct
the steam gun at a separate piece of cloth
until the steam is emitted evenly.
Note: The heating of the steam cleaner is
turned on in regular intervals during the op-
eration of the appliance in order to maintain
the pressure in the boiler at a constant level.
When the heating is turned on, the orange
indicator lamp (heater) lights up.

Adjusting the Steam Quantity

Use the steam switch (B4) to regulate the
discharged steam.
The lock of the steam switch (B3) also allows
for steam volume regulation.
Switch in front position: no steam (child con-
trol)
Switch in middle position: reduced steam
amount
Switch in back position: maximum steam
amount

Refilling Water

Water needs to be filled into the boiler, if the
steam volume decreases during work and no
more steam is emitted in the end.
Note: The safety lock (A4) cannot be opened as
long as slight pressure remains in the boiler.
All manuals and user guides at all-guides.com
A residual amount of steam may be emitted
when you open the safety lock. Be careful when
opening the safety lock, there is a risk of scald-
ing.
If the boiler is hot, there is the risk of scalding as
the water may splash back during the filling proc-
ess! Do not fill any detergents or other additives
into the boiler!
Push the steam lever (B4) until steam dis-
charge stops. Now, the boiler of the appli-
ance is unpressurized.
Disconnect the mains plug (A7) from the
socket.
Remove the safety cap (A4) from the device.
Danger
Fill the boiler with a maximum of 1.2 liters of
fresh tap water.
Danger
Screw the safety cap back onto the device.
Insert the mains plug into a socket.
The orange indicator lamp (A3) goes out af-
ter approximately 8 minutes.
The steam cleaner is ready to use.

Turning Off the Appliance

Disconnect the mains plug (A7) from the
socket.
Press the cover of the appliance (A1) con-
nector to the bottom and disconnect the
steam plug (B6/H5) from the appliance con-
nector.

Storing the Appliance

Illustration
Put the extension pipes (E1) into the large
acessory compartments (A5).
Insert the manual nozzle (D1) and detail noz-
zle (C1) onto each extension pipe.
Put the round brush (C2) into the medium
acessory compartments.
Hook the floor nozzle (F1) into the parking
position (A6).
Wrap the steam hose (B5) around the exten-
sion pipes and insert the steam pistol (B1)
into the floor nozzle (F1).
English 17

Publicité

Table des Matières
loading

Table des Matières