Schluter Systems DH E RS D/BW Guide De L'utilisateur page 8

confirm your choice by pressing down the Mode or Day/Hr
button. You can also press down the desired day of the week
button without using the + or - button and confirm your choice
using the Mode or Day/Hr button.
3. The two figures indicating the hour blink. You must adjust
them using the + or - button and confirm your choice by
pressing down the Mode or Day/Hr button.
4. The two figures indicating the minutes blink. You must adjust
them using the + or - button and confirm your choice by
pressing down the Mode or Day/Hr button. The adjustment
is then completed and the thermostat returns to the previous
mode.
At any time, you can exit the adjustment mode of the day and the
hour by pressing down the Exit button or by not pressing any
button during 1 minute.
In case of a power failure, the thermostat is self-sufficient for 2
hours. If the failure lasts less than 2 hours, the thermostat saves
the adjustment of the hour and the day of the week. When the
power is restored after an extensive failure (more than 2 hours),
the hour and the day of the week are recovered, but you must
update them.
Display in Degrees Fahrenheit/Celsius
The thermostat can display the ambient temperature and the set
point in degrees Fahrenheit (standard factory setting) or Celsius.
Adjustment procedure for degrees Fahrenheit/Celsius display.
1. To switch from the degrees Fahrenheit to the degrees Celsius,
and conversely, simultaneously press down the + and -
buttons for more than 3 seconds until the
2. Press down the + button to switch from the degrees Fahrenheit
to the degrees Celsius, and conversely. The degree Fahrenheit
or Celsius symbol is displayed.
3. When the adjustment is completed, press down the Exit
button or do not press down any button during 5 seconds to
exit the adjustment function.
8
icon blinks.