Schluter Systems DH E RS D/BW Guide De L'utilisateur page 10

meaning that the set point can change automatically up to 4
times a day. The period order is not important.
From this mode, the screen displays the temperature, the set
point, the hour, the day of the week and the current programmed
period number (1 to 4; as applicable).
After programming a day of the week, you can copy this setting;
see "Copy of the Programming".
1. To access the Programming mode, press down the day of the
week button that you want to program (Mon to Sun). Once you
release the button, the selected day of the week is displayed,
the icon blinks and the period number 1 blinks too.
2. Select the period number (1 to 4) that you want to program
using the + or - button. For each period, the hour and the set
point are displayed. The hour displays --:-- and the set point
displays -- if there is no programming for the period. You must
confirm the period by pressing down the Mode button.
3. The two figures representing the hour blink to indicate that you
can adjust them (from 00 to 23) using the + or – button. You must
confirm the adjustment by pressing down the Mode button.
4. After confirmation, the figures representing the minutes (the
last 2 figures) blink. You can adjust and confirm them in the
manner described in point 3. Note that the minutes can only
be adjusted by increments of 15 minutes.
5. The period set point blinks and you can adjust it using the
+ or - button. You must confirm the adjustment by pressing
down the Mode button.
6. After set point confirmation, the programming is completed.
The following period number blinks. For example, if the
previously programmed period was 1, period 2 blinks. It is
then possible to continue the programming of this period by
pressing down the Mode button. You can also select another
period using the + or – button.
7. At the end of period 4 programming, you automatically exit the
Programming mode.
10