Publicité
Les langues disponibles
Les langues disponibles
First Start-up
At the first start-up, the thermostat is initially in the Man (manual)
and
modes. The temperature is displayed in degrees Celsius
and the standard factory set point adjustment is 21°C (70°F).
The hour displays --:-- and must be adjusted before switching
to the Auto or Pre Prog mode. The maximum floor temperature
is limited to 28°C (82°F).
Ambient and Floor Temperature
The figures displayed below the
temperature, ±1 degree. The figures displayed below the
icon
Both temperatures can be displayed in degrees Celsius or
Fahrenheit (see "Display in degrees Celsius/Fahrenheit").
Temperature Set Points
The figures displayed beside the
(
) or the floor (
displayed in degrees Celsius or Fahrenheit (see "Display in
degrees Celsius/Fahrenheit").
Out of any adjustment mode, press down the + button to
increase the set point, or the - button to decrease it. Set points
can only be adjusted by increments of 1 degree. To quickly scroll
through the set point values, press and hold down the button.
Maximum Floor Temperature Limitation
At any time, the floor temperature (in
less than 28°C (82°F) in order to avoid overheating caused by an
excessive heating request, which could damage some materials
or be detrimental for health.
Adjustment of the Hour and the Day of the Week
Adjustment procedure of the hour and the day of the week.
1. Press down the Day/Hr button, whether it is in Man, Auto or
Pre Prog mode.
2. At this moment, the
you can adjust the day of the week using the + or - button and
indicate
the
) temperature set points. They can be
icon and the day of the week blinks and
icon indicate the ambient
floor
temperature,
icon indicate the ambient
mode) is maintained at
±1
degree.
7
Publicité
