Schluter Systems DH E RS D/BW Guide De L'utilisateur page 15

View of the Preprogramming
The view of the selected preprogramming is made in a way
similar to the Auto mode programming. However, it is impossible
to modify the preprogramming.
You must proceed as follows:
1. Press down the button corresponding to the day to view
(buttons Mon to Sun). When the selected day is displayed, the
icon and period number blink.
2. Choose the period number (1 to 2) to view using the + or -
button. For each period, the hour and set point are displayed.
You can also press down the Mode button to switch to
period 2. If you press down the Mode button when period 2 is
displayed, you exit the View mode.
At any time, you can exit the View mode using one of these
3 methods.
1- Press down the button of the day you are viewing.
2- Press down another day to view it.
3- Press down the Exit button.
If you do not press down any button during 1 minute, the
thermostat quits the view mode. At any time, it is possible to
change the day to be viewed by pressing down the desired day
button.
Mode
/
To switch from the
press down the A/F button (when you are not in any adjustment
mode). Then, the temperature set point will become the same
as the or
if a set point is programmed for the current period, it will take
this value.
mode to the
mode temperature, as applicable. However,
mode, or conversely,
15